|
|
|
Drop-in
Ceiling Dome
- Mirror, 2-way Mirror or Smoked Finish
|
|
|
Full
Dome Mirror "DI"
- One Piece Construction
- Replaces a
Drop-in Ceiling Tile
- Full or
Partial Mirror Options
- Only
Available in Acrylic
- The Flat Area
Around the Dome is Painted an Off-white to Closely Match the
Color of a standard Ceiling Tile.
Smoked
Finish "SM"
|
See-Through
Drop-in Dome Mirror "ST"
- When Mounting a Camera, a 2'
x 2' Piece of Pressboard is Recommended to Mount the Camera and
Act as a Backlight Shield.
- Mounting Panel Replaces a
Standard 24"x24" Drop in Ceiling Panel
Uses
- Monitor Office Areas
- See Around Corners of
Intersecting Hallways
- General Surveillance
|
|
| Three
Finishes - Mirror "DI", See-through mirror
"ST" and Smoked "SM" (Inside use only)
|
|
|
| General
information regarding the Full Dome See-through Mirror (RAV18ST and
RAV24ST). The camera mounting panel or camera mounting hardware is not
included with the drop-in transparent mirrored domes. A 23 13/16 x 23
13/16 inch hardboard panel works very well as a plate to mount the camera
and block light coming from above the ceiling. In areas where the
room is very bright, a light source is close to the dome or the dome is
located near an outside window allowing direct sunlight into the area
around the dome, enough light could penetrate the mirror to reflect off
the camera. This will cause the camera to see a faint reflection of
itself. Installations which could potentially have enough light to
penetrate the dome mirror should allow for testing. If this is a concern,
a light block should be fabricated from flat black card stock (or paper)
to block the light coming through the dome mirror. Only the area in front
of the lens should be open to allow the light to reach the camera.
Currently Reflection Products does not offer a light blocker for this
situation. While this situation is not common, it has been reported to us
and we feel it is important to provide this information to you.
|
|
|
|
